An excellent addition to the motorcycle trailer accessory. Each side of this motorcycle tie down is rated to 400kg or 881lb. We only use industrial grade tie downs and rachetting system supplied by the world leader in cargo restraint systems, Ancra. A whooping 800kg or 1762lb of grunt. This motorcycle tie down means that this will be the last time you'll ever be looking over your shoulder to see if the bikes still there or pulling over the side of the road to resecure the straps because they've come lose.  

A new innovation in motorcycle tie downs, you can tie down any type of trail, road, supermotard, motard,superbike, tourer (except fixed panniers models). 

You thought we'll sure it could hold a trail bike down but surely not a 200kg plus road bike. Well, again this motorcycle tie down firmly grips in to the rear tyre like glue and 800kg or 1762lb holding power that bike will not be moving until you let it go. Check out the photos and the videos in our GALLERY. You won't believe your eyes. This unique system allows the supension to freely move but holds the bike cemented to the trailer. You'll see what happens when this dude tries to dislodge the bike from its position.  

Fitting Instructions

To check that TyreDown™ will fit your bike drape a length of string or rope over your rear tyre with each end of the rope held to the proposed fixing points 750mm to 900mm apart. If there is no interference with any part of your bike the TyreDown™ will fit.

See illustrations below.

The new TyreDown™ system is simple to setup. The following steps will assist you in setting up your TyreDown™ product correctly. PLEASE NOTE: Trail Bike and Road Bike versions are fitted in exactly the same.

• Anchor points must be fixed securely to a strong base 750mm to 900mm apart (29.5 inches to 35.5 inches) and approximately 50mm (2 inches) forward of the rear wheel axle.
• The rear wheel should be positioned mid way between the anchor points.
• Place the TyreDown™ cradle over the rear tyre with the axle centered. (Road TyreDown™ shown above)
• Tyrebelt is fitting straight over no need to move back over the tyre.

Check out what one of our customers did using a Ventura stand and TyreDown™. Click Here  

What NOT to do shown below

Remove any slack from the strapping before tightening with the ratchets. Refer to the tag on the ratchet straps for more information.

The entire job takes less than 1 minute.

Warning: Improper fitting or use of TyreDown™ may result in the motorcycle FALLING off the trailer or ute cause property damage or loss of life. ALWAYS DOUBLE CHECK. If you have trouble and require assistance, you can contact us via email at support@motorcycletiedownpro.com

GENERAL MAINTENANCE: ALWAYS CHECK WEBBING, NUTS AND BOLTS ATTACHMENTS TO THE RATCHET BEFORE USE.

Bikes the Tyre Down Fits

The Tyredown™ and Tyrebelt fit most bikes below are examples of which one they fit...If it not on here it doesn't mean it won't fit. Email us