Featured Item!

To check that Tyre Down will fit your bike drape a length of string or rope over your rear tyre with each end of the rope held to the proposed fixing points 750mm to 900mm apart. If there is no interference with any part of your bike the Tyre Down? will fit. See illustrations below. The new Tyre Down™ system is simple to setup. The following steps will assist you in setting up your Tyre Down? product correctly. PLEASE NOTE: Trail Bike and Road Bike versions are fitted in exactly the same

Anchor points must be fixed securely to a strong base 750mm  to 900mm apart (29.5 inches to 35.5 inches) and approximately 50mm (2 inches) forward of the rear wheel axle. The rear wheel should be  positioned mid way between the anchor points. Place the TyreDown? cradle over the rear tyre with the axle centred. (Road Tyre Down™ shown above) Tyrebelt is fitting straight over no need to move back over the tyre.

Check out what one of our customers did using a Ventura stand and Tyredown. Click Here

What NOT to do shown below

Remove any slack from the strapping before tightening with the ratchets. Refer to the tag on the ratchet straps for more information. The entire job takes less than 1 min
Warning: Improper fitting or use of TyreDown? may result in the motorcycle FALLING off the trailer or ute cause property damage or loss of life.
ALWAYS DOUBLE CHECK.
If you have trouble and require assistance, you can contact us via email at mailto:support@motorcycletiedownpro.com
GENERAL MAINTENANCE: ALWAYS CHECK WEBBING, NUTS AND BOLTS ATTACHMENTS TO THE RATCHET BEFORE USE.